If your Fisher & Paykel dishwasher is displaying an error code, it’s designed to indicate issues such as drainage problems, water supply faults, heating errors, or sensor-related issues. Understanding these codes can help you decide whether a simple reset may resolve the issue or if professional service is required.
Common Fisher & Paykel Dishwasher Error Codes
F1 – Water leak detected
The F1 error indicates that water has been detected in the base of the dishwasher, triggering a safety shutdown.
What you can try: Turn off power to the dishwasher and allow it to dry for up to 24 hours.
When to call service: If the error returns, a leak should be inspected by a technician.
F2 – Drainage error
This code appears when the dishwasher is unable to drain water properly.
What you can try: Clean the filter and ensure the drain hose is not kinked or blocked.
When to call service: Persistent drainage issues usually require professional attention.
F3 – Water inlet error
F3 indicates the dishwasher is not filling with water as expected.
What you can try: Check that the water supply tap is fully open and household water pressure is adequate.
When to call service: Ongoing filling problems may require service.
F4 – Heating error
This error means the dishwasher is not heating the water to the required temperature.
What you can try: Switch the dishwasher off at the power for several minutes, then restart.
When to call service: Heating system faults usually need professional repair.
F5 – Temperature sensor fault
The dishwasher cannot correctly measure water temperature.
What you can try: Power reset the appliance.
When to call service: Sensor replacement may be required.
F6 – Motor or circulation fault
This code indicates a problem with water circulation inside the dishwasher.
What you can try: Check that spray arms can rotate freely and are not obstructed.
When to call service: Persistent circulation issues should be inspected professionally.
F7 – Water level fault
F7 appears when the dishwasher detects abnormal water levels during operation.
What you can try: Restart the dishwasher after turning off power briefly.
When to call service: Repeated water level errors require service.
U1 – Water pressure issue
This code indicates that incoming water pressure is too low for proper operation.
What you can try: Ensure the household water supply is functioning normally.
When to call service: If pressure issues continue, a technician may need to inspect the installation.
How to Clear a Fisher & Paykel Dishwasher Error Code
Many Fisher & Paykel dishwasher error codes can be cleared by switching the dishwasher off at the power supply for several minutes and then restarting it. If the code returns, it usually indicates an underlying issue.
When to Call Service
You should contact a qualified technician if an error code keeps reappearing, the dishwasher stops mid-cycle, or you notice leaks, unusual noises, or poor cleaning performance.
Frequently Asked Questions
Can I keep using my Fisher & Paykel dishwasher with an error code?
It’s best to stop using the dishwasher until the error is resolved to avoid further damage.
Do Fisher & Paykel dishwasher error codes reset automatically?
Some temporary errors may clear after a reset, but recurring codes usually need attention.
Are Fisher & Paykel dishwasher error codes the same across all models?
Most Fisher & Paykel dishwashers use similar codes, but exact meanings can vary by model.