Electrolux Washing Machine Error Codes (What They Mean + Fixes)

by

If your Electrolux washing machine is displaying an error code, this guide explains what the code usually means, the most common causes, and safe checks you can try before calling service.

Note: Error codes can vary slightly by model and series, but the explanations below apply to most modern Electrolux front-load washing machines.

Common Electrolux Washing Machine Error Codes

E10 — Water Inlet Error

What it usually means

  • The washer is not filling with water fast enough.

Try this

  1. Ensure the water tap is fully open.
  2. Check inlet hoses for kinks or twists.
  3. Clean the inlet hose filter screens.
  4. Confirm household water pressure is normal.

Call service if

  • E10 persists after cleaning filters and checking supply.

E20 — Drain Error

What it usually means

  • The washer cannot drain water properly.

Try this

  1. Clean the drain pump filter.
  2. Check the drain hose for kinks or blockages.
  3. Ensure the standpipe or sink trap is not blocked.

Call service if

  • The pump runs but water does not drain.

E40 / E41 — Door Lock Error

What it usually means

  • The door is not closed or not locking correctly.

Try this

  1. Re-close the door firmly.
  2. Remove any laundry caught in the door seal.
  3. Power off for 2 minutes and retry.

Call service if

  • The door will not lock or the error returns immediately.

E60 — Heating Error

What it usually means

  • Water is not heating to the expected temperature.

Try this

  1. Run a cold wash to confirm other functions work.
  2. Avoid overloading the machine.
  3. Clean filters to improve water circulation.

Call service if

  • E60 appears on multiple cycles.

E90 — Control Board / Communication Error

What it usually means

  • A communication issue between electronic components.

Try this

  1. Turn off power at the wall for 5 minutes.
  2. Restart and test a short cycle.

Call service if

  • E90 reappears (control diagnosis required).

EF0 / EFO — Excessive Foam Detected

What it usually means

  • Too much detergent or incorrect detergent type.

Try this

  1. Reduce detergent amount.
  2. Run a rinse cycle without detergent.
  3. Use only HE-rated detergent.

Call service if

  • The error continues with correct detergent usage.

EF1 — Drain Pump Blocked

What it usually means

  • The drain pump or filter is obstructed.

Try this

  1. Clean the pump filter thoroughly.
  2. Check for coins, lint, or debris in the pump housing.
  3. Restart the machine.

Call service if

  • EF1 returns after cleaning.

How to Clear an Electrolux Washing Machine Error Code

  1. Turn the washing machine off.
  2. Turn off power at the wall for 5 minutes.
  3. Restore power and run a short test cycle.

If the error returns immediately, the issue is likely active.

When to Call Service

  • Repeated inlet or drain errors
  • Heating or control board faults that persist
  • The door will not lock at all
  • Burning smells, tripped breakers, or visible leaks

FAQ

Can detergent cause Electrolux error codes?

Yes. Excess detergent can cause foam-related errors and interfere with drainage and sensors.

Why does E20 happen after washing towels?

Heavy or lint-producing loads can block the pump filter and slow draining.

Should I keep resetting the washer?

No. Repeated resets without fixing the cause can worsen the underlying issue.